More than 7 in 10 Energy Performance Certificate (EPC) rated homes in the lowest-performing local authority fail to reach Band C, according to new analysis of official housing data from the Office for National Statistics (ONS).
The research, conducted by Brick Wholesale, mapped the proportion of dwellings with a valid EPC achieving Band C or above across England and Wales. EPCs rate energy efficiency from A, the most efficient, to G, the least efficient, with a score of 69 or above qualifying for Band C.
The national median score is 69 in England, placing the typical rated home just inside Band C. In Wales, the median score is 68, falling into Band D.
The analysis highlights a sharp geographical divide in energy efficiency across regions. Five of the 10 lowest-performing areas are located in Wales, while London accounts for half of the top-performing local authorities.
Lowest proportion of homes achieving EPC Band C or above
| Region Name | Local Authority | Rank | Percentage EPC C or Above |
| Wales | Gwynedd | 1 | 27.79% |
| Wales | Ceredigion | 2 | 31.51% |
| West Midlands | Staffordshire Moorlands | 3 | 31.66% |
| East of England | Castle Point | 4 | 33.45% |
| North West | Pendle | 5 | 33.82% |
| North West | Hyndburn | 6 | 34.49% |
| Wales | Powys | 7 | 34.81% |
| North West | Blackpool | 8 | 36.24% |
| Wales | Carmarthenshire | 9 | 36.56% |
| Wales | Isle of Anglesey | 10 | 37.04% |
Highest proportion of homes achieving EPC Band C or above
| Region Name | Local Authority | Rank | Percentage EPC C or Above |
| London | Tower Hamlets | 1 | 82.21% |
| North West | Knowsley | 2 | 74.40% |
| North West | Salford | 3 | 71.18% |
| South East | Milton Keynes | 4 | 69.38% |
| London | Southwark | 5 | 69.33% |
| London | Hackney | 6 | 68.45% |
| London | Newham | 7 | 67.16% |
| London | City of London | 8 | 67.07% |
| South East | Dartford | 9 | 66.80% |
| South East | Eastleigh | 10 | 66.48% |
Mounting pressure from energy price caps
These regional variations emerge as households face rising energy costs. Ofgem increased its price cap by 13% for the period covering 1st July – 30th September 2026 for a typical dual-fuel household paying by Direct Debit on a standard variable tariff. The cap covering October – December is due to be published by 26th August.
Cornwall Insight’s final forecast, published on 19th August, predicts a further 4% increase from October. This would raise the annualised estimate for a typical household under Ofgem’s updated consumption assumptions from £1,663– approximately £1,729, although actual bills vary based on consumption.
Max Fetisov, Head of Marketing and Ecommerce at Brick Wholesale, commented on the findings: “What stands out from these figures is just how dramatically the energy performance of housing can vary across England and Wales. In Gwynedd, more than 7 in 10 EPC-rated homes fall below Band C, while in Tower Hamlets more than 8 in 10 achieve C or above.”
“A large part of that difference can be explained by the age, type, and construction of the housing stock rather than simply how individual households use their heating. Newer properties tend to be substantially more energy efficient: ONS data puts the median EPC score for homes built after 2012 at 84, firmly within Band B, while flats and maisonettes have the highest median score of any property type, at 74.”
“When it comes to brick homes, the important distinction isn’t usually whether one particular variety or colour of brick is more energy efficient than another. How the wall is constructed and insulated matters much more.”
“Many older homes were built with solid brick or stone walls, whereas cavity wall construction became increasingly common during the twentieth century. Government housing data says almost two-thirds, 64%, of English homes built before 1945 had uninsulated solid walls, while just 29% of pre-1945 homes achieved an energy efficiency rating between A and C.”
“By comparison, newer brick and block homes are far more likely to have an insulated cavity between the inner and outer masonry leaves. Among homes built after 2012, 84% had cavity wall insulation. That doesn’t mean brick itself is inefficient, it means modern wall systems can combine masonry with insulation in a way older solid-wall construction simply wasn’t designed to do.”
“The latest English Housing Survey also makes clear that wall construction and insulation are closely related to the age of a home, and that insulation can reduce heat loss and heating costs. More than half of English dwellings now have cavity or solid-wall insulation, but there remains a significant stock of homes where walls or lofts are poorly insulated.”
“House type can make a difference too. A detached house has more external walls exposed to outdoor temperatures, while a mid-terrace shares walls with neighbouring homes. Flats can share walls, floors, and ceilings with other heated properties, which is one reason flats and maisonettes tend to perform particularly well in EPC data.”
“Older brick and stone homes can absolutely be made more energy efficient, but the correct approach can be more complicated. Traditional solid-masonry buildings manage moisture differently from modern cavity-wall construction, and Historic England warns that unsuitable insulation can prevent walls drying naturally and allow moisture to accumulate in the building fabric.”
“For homeowners, that means the first question should not simply be ‘what brick is my house made from?’ but ‘how are my walls constructed?’ Knowing whether they are solid or cavity walls, whether they have appropriate insulation, how well the loft and roof are insulated, the quality of the windows and doors, and the efficiency of the heating system gives a much fuller picture.”
“That becomes particularly important with another possible energy price increase approaching. The cap has already risen 13% this summer, and the latest independent forecast points to another roughly 4% rise in October. If that forecast is borne out, reducing unnecessary heat loss will become even more valuable to households.”
“Two brick houses can look almost identical from the street but need very different amounts of energy to stay warm. It is the whole construction of the home, not simply the brick you can see, that determines how well it performs.”